plasma cutter you have to notch out the frame if you want to go low or the control arm will hit

like I said the rear is easy. you have to take the leaf springs out

and in the same mounts you put the rods to the link suspension

and in the middle of the axle you put a triangler fixture for the middle

and install the bags, install shocks in the middle
don't forget because you are getting all this suspension play that you didn't have before you are going to have to make the brake lines longer, bleed the brakes again.

and that is only the rear

the front you have to take the brake assembly completly off, remove some of the plastic, notch out the frame so the bag doesn't hit, install shocks, I belive in the kit they provide you with new control arms (you are going to have to use new control arm) and then just install everything back.

hope this helps i'll tell you about it tomorrow
-garrett