I decided to give uberdata a try on my friends turbo b16 civic since it now has 3 bar support....

Here's the setup:
b16a block
Je 9:1 pistons
crower rods
GE blockguard
unported b16a head
ferrea valvetrain
type r cams
precision sc61
3" downpipe and exhaust
VP C16 fuel
880cc injectors

The tuning went smoothly until I started to bring it past 17 psi. No matter what I did it would not run any leaner than 10.8-11.1. I pulled 10% out of the 23 psi column between two runs running about 20-21 psi boost and there was no change at all to the a/f ratio. This made me nervous, as the 23 psi fuel values were getting real close to those in the 17 psi column. So I turned it back down to 17 psi for now.

I had no problems at all with boost levels below 17 psi, I was able to get a just about solid 12.8:1 across the board from 10 -17 psi.

I think someone else on this forum had a similar problem as well. Also,I am using the latest version of the software from this website. I'm pretty sure this has to be a bug in the software..just thought I'd let you guys know about it.