TC bushings really sucked to replace.
I did torch one of them out, and the other took some "convincing" with a sledge hammer and 2 sockets. A 2 1/4" socket (yea.. 1.5" drive or something) and a 2 5/8" socket. I think those are the right sizes. Set down the big socket. Place the TC rod edge around the socket lip. Set the smaller socket onto the metal rim of the stock bushings. Swing and watch sockets go flying everywhere. If you're lucky, the bushing comes out.
But.. if you simply have access to a press, it's a 5 minute swap.
-Jeff