Originally posted by RONIN
it is a common misconception that exhaust needs some back pressure. the problem with using an exhaust that has too large a diameter is that it slows exhaust gas velocity. part of the header's purpose is to balance exhaust gas flow and actually use one cylinder after another to create a vacuum effect, pulling the gas out as the piston pushes it out. if you wanted back pressure then you could just stick something in the way and keep the large diameter piping, it would crap out the whole deal.
2.25 is fine for your avg exhaust, but i would also recommend a mandrel bent cat back setup, i loved my hks super dragger, it was 2.25 with a cannister muffler, and had a small resonator in the mid pipe (after cat, pre axle).
the 2.5 is also fine, but if you don't need high end breathing then you would just lose power on the bottom end due to the larger diameter on the collector, and if running it into a 2.25 exhaust its just a waste. stay away from this size for an LS
if you are budget minded than you could always just pick up a glass pack, magnaflow makes and excellent 2.5 diameter, in 18 and 24 inch lengths. get a mandrel 45 or 90 to make a turn down. for some reason the magnaflows flow better than a straight pipe.
very correct. You don't ever want back pressure. It's the scavengering effect that you're looking for.
Basically, if you're looking for a little more prep in the lower rpm range and you're making around 150-160 whp (hypotheically speaking) then 2.25" would suit your needs. I was making around 180whp in my Crx and really liked the 2.5" exhaust. If possible, try to get a mandrel bent system, that way there isn't varying diameters that the exhuast gas flow through.