FS: Stage 5 port and polished bare LS head
Thread Starter
Troll extraordinaire
Joined: Feb 2007
Posts: 1,471
Likes: 0
FS: Stage 5 port and polished bare LS head
I have this Stage 5 ported and polished LS head that i no longer need. all work was done on her by Matt @ HPS cylinder heads who is the best in the area in my opinion. p&p job was $870 alone, im asking $650. buy it and make crazy power. send me a message if ya have any questions.
__________________
engine building &amp;amp;best
Joined: May 2003
Posts: 11,971
Likes: 0
so it was run after it was ported or did they port it dirty?
__________________
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
Registered User
Joined: Jan 2008
Posts: 581
Likes: 0
Thread Starter
Troll extraordinaire
Joined: Feb 2007
Posts: 1,471
Likes: 0
HPS Cylinder head is literally right next to where this head is at... like, i can spit on the front door.. and i do.. often.. lol
matt might have a work order for the head.. if he doesnt ill have him make one.
matt might have a work order for the head.. if he doesnt ill have him make one.
__________________
Registered User
Joined: Dec 2009
Posts: 437
Likes: 0
looks like some random dude went too far and now is trying to get rid of it...the proof will be when it sells for $200 or lower...i do port work and this head dosen't look like a pro did it...whats the cc of the 4 chambers and whats the cfm on all ports???what cam lift dose he say should be used???sorry gotta look out for my fellow TR ppl who work hard for $$$
