I have a complete Granny's speed shop swap kit for a 2nd gen RX7 , including the LS1 specific Ron Davis Radiator, brackets, etc, and Prothane Engine and tranny mount, all brand new ready to go. The driveshaft has a Turbo 400 yoke on it. PM or email for pics. $1200 invested will let go for $900

I also have an 86 RX7 Hardtop. Car is a roller. I have removed pretty much the entire wiring harness and made some modifications to the radiator support. Car comes with an aluminum hood, a brand new blue dashpad that I found on ebay, and a set of grey/black door panels in great condition. Title in hand, car is definitely a project. Title in hand, $500 PM or email for pictures.

I also have a GMPP single plane LS1 intake, modified for Fuel rails (included) plus an intake elbow from aaron at sheet metal 6.0 powerstroke intake elbow intake elbows elbow aluminum camaro ls1 lt1 mustang ls1 valve covers Aaron Larsen , IntakeElbows.com Incuded is an infiniti 90 MM cable throttle body. $500

NIB Cam Motion Hydraulic roller turbo grind. I called Kip and told him I wanted something that would take me to 1000 HP and this is what he sent me. Cam card included, it is bigger than what you would think. $300

NIB set of morel lifters, these cost me $550 will let go for $400

Brand new set of ET 225's cylinder heads NIB, paid $2600 + shipping will let go for $2200

DM Performance Main Girdle for LS1. For the ultimate in bottom end strength. This includes girdle specific ARP studs $500 Brand new.

Unassembled Turbo 400. Includes new JW ultra bell, cast aluminum pan, RMVB w/brake, early Drum, new red frictions koleen steels, upgraded center support. $600

Fabricated sheet metal valve covers, +1" tall $250

email me jason.crossley {at} gmail dot com , pm is fine too. Stuff is located in Lutz if you want to come see it.

 

no ls1 for sale though ?

 

Well, I am in the middle of assembling my forged bottom end LS2, but I am buying a vette, I had plans for it.

 

well would you be willing to sell just the adapter brackets from the kit? i already have the sbc setup they sell, but am in need of the adapter brackets for an LS/LQ motor.

 

nevermind.

 

You can make them yourself ( do a search on LS1tech in the swap forum for the plans) or buy them off ebay for $70 bucks.