i built this engine for a boat and now dont want the boat so i am selling the motor and boat separate
its NOT half assed together, the parts are all new and NO corners cut since when i was building it i didnt want to get stranded 20 miles out
but anyways its never been started, if anyone doesnt buy it within a week i will probably build a running stand and start it up but then the price will go up aswell, if you have any doubts on my engine building capabilities you can use my drag car engine as evidence engine competency.

350 block (LS based) 4 bolt mains bored .030 over
new stock replacement crank with clevite bearings
stock rods- magnufluxed
brand new hypereutectic pistons with power seal rings
9:1 compression
CAM is .465 lift intake .488 exhaust 224dur intake 234dur exhaust @.050 114 lobe center rpm range 1500rpm - 5250 rpm
hydraulic lifters
Edelbrock torker II intake
750 cfm holley double pumper (a lil overcarbed but its what i had on hand it will work just fine)
new shorty block hugger headers wrapped in header tape
heads are stock 1.72 1.50 iron but polished ports with casting out. mildly ported and heads, intake, headers are port matched. all springs, valves, and rockers checked and replaced where needed
hei dizzy (used but should work fine if not the only part needed would be a coil) new accel high temp silicon plug wires
chrome valve covers and air cleaner
new waterpump
new starter
painted chevy orange\red
complete from oilpan - aircleaner
will conservatively make about 250 hp
i have roughly $1400 wrapped up in this not including my labor, but i just have no use for it
$1000 this is a brand new engine 0 miles

 

up

 

buy this

 

no one wants a new engine? make me a good offer

 

just b\c i built it for a boat, doenst mean its not car capable. its the same thing. standard rotation, nice street cam. this a a perfect v8 upgrade for you v6'ers and s10 guys.

 

added a pic on the opening thread

 

my boss is in need of an engine for his boat. the 350 he pulled out was toast. I'll let him know about yours tomorrow.

 

ok sounds good, to be honest i cant believe how long this has been on here only selling for $1000, and nobody has been breaking the door down to buy it. i know that sbc are cheap to put together but not a bottom to top built for $1000, parts are more expensive than that, not to mention labor costs

 

If you wanna seperate with soem parts i might be interested shoot me a PM if you ever wanna

 

yeah how much for just the short block..no top end,or pan and pump.