....

 

You have your handfull! p-m me your number I must have an old one

 

Chris I have the back panel part from a 92 coupe I am junking. Do you have a welder? If not I have a miller 200 mig and a plasma cutter so I could fix that for you if you need me to. If not I will cut the back panel off and when you are in the area I will set it out by the gate

 

Yep I do have my hands full, BUT tha last coupe that I did, was in similar condition as this one. It will take alot of time and even more work, but it will get there!!!!

 

And it was clean for sure! Keep the progress posted, I like to see when cars are revived. Have you thought of what motor set-up you wanna run?

 

It might be cheaper to find another coupe that doesn't need all that bodywork. A coupe with a rust free body shouldn't be too hard to find. I found quite a few during my search. Good luck with the project.

 

With what I got the coupe for and the availability of coupes I kinda doubt it. People are asking ridiculous money for coupe rollers anymore. And you never start finding problems until you rip it apart. I could sell this and look for another one and find one in as bad or worse shape. It does need alot of work, but I have nothing but time to do it!!

 

I say that if you are up to the challenge and have the time to do it then go for it....heck if you get frustrated during the resto you have a punching bag there to take it out on....just remember your focus determines the end result and not the shit you are going through....gl in the resto and keep us updated