sohc vtec hf
Thread Starter
PSSHHH x2
Joined: Apr 2002
Posts: 14,291
Likes: 0
any problems or things i would have to alter to suspension/engine bay/wiring to get an OBD2 sohc vtec in
__________________
El Pendejo Loco
2002 Suzuki Hayabusa
1507 "dry" block
Brocks megaphone
Spencercycle 10" swingarm
MPS auto shifter
Hays convertible clutch
Yea, that about sums it up...
El Pendejo Loco
2002 Suzuki Hayabusa
1507 "dry" block
Brocks megaphone
Spencercycle 10" swingarm
MPS auto shifter
Hays convertible clutch
Yea, that about sums it up...
Guest
Posts: n/a
well if you want to use the obd2 dist/manifold/ecu youll have to rewire your car from obd0 to obd2 (ouch!!). Or you can stay with your obd 0 electronics (I suggest if youre going this route to find an ECU/intake mani/etc. from a crx si) and you can use a VTEC controller to control the VTEC.
or....you can buy the zdyne 1 wire conversion and make your wiring headaches go away.....
if it was me (since I dont have any money) Id rewire to run with the engines manifolds/dist/ECU.....but thats me
L.
or....you can buy the zdyne 1 wire conversion and make your wiring headaches go away.....
if it was me (since I dont have any money) Id rewire to run with the engines manifolds/dist/ECU.....but thats me
L.
Guest
Posts: n/a
i only suggest the zdyne ecu on pre-obd sohc vtec swaps due to the fact threr are no ecus you can use. so basiclly thats the only mods you will ahve to do wiring wise you will just have to run one wire from the vtec selonoid to the ecu. no other mods.
