hey all i changed my passenger side cv axle last night cause i needed a new one, when i got done i made it like about a mile and it worked its way out of the tranny? i towed it home, put it back in and then 20 minutes later did it again.

1. the axle is from carquest

2. i think the guy gave me a drivers side.

3. i never compared the old and new one.

4. ye it is a B series swap

5. it sucked really bad

 

Does it have the retaining clip on it? What year are the axles and intermediate shaft, tranny, car, ect?

 

you have to hit a axel into the tranny it has to snap back in place!!!!!use a rubberhammy Or put a towal around the end and use a hardhammer

 

fixed it was a sohc cam axle

thanks a fuckin lot car quest.

autozone kicks your ass

 

haha gimp

 

Good idea to always compare new/old parts before swapping.
Glad you got it taken care of.
One a side note, I'd be wary of any of the axles floating around our local autoparts shops (ie: Discount, Napa, etc.). I've had very bad experiences with all of them failing (less than a week of use) and have since then stuck with stock. Pricier yes, but at least it's not a poorly done rebuild.

 

very true im a retard for not buying one from honda, but i thiink i would have had to take out a loan to get them.

y2jay, cut your mullet.

J/K

 

y didt u get it redone by mikes drive line

 

i dont even know where that is, made any progress on you motor yet??????????