Well I started Building this engine and then got bored so now I am selling everything. The Block is a B16 that has been sleeved, bored to 84.5mm and runs a LS crank. ACL race bearings were used in the Build and the Bottom end and machine work has been done by Golden eagle. The block also has a endyne block girdle, ARP main studs and head studs. Eagle h- beam roda and cp pistons. 9.5/1 cr. Type r oil pump, Brand new oil pan and all bolts on this block are new. New head gasket purchased from Golden eagle, Head is also a B16. it runs dual valve springs on both the intake and exhaust. B16 IM, Golden eagle fuel rail, RC inj. 750cc, synapse eng fuel presure reg. Skunk 2 pro series cam gears, Custom powder coated valve cover. Rev hard turbo manifold, Garrett super 60 turbo, Synapse eng wastegate, 3" down pipe, 2 1/2 " intercooler piping, Huge front mount intercooler, Synapse eng BOV, Golden eagle vacume manifold, Hondata s300 ecu. This engine Has never been started. I started putting it together and never put it in a vehichle.

I am asking $5500.00 for everything listed here. but for $8000.00 obo you can have everything I have wich is a 1996 Integra, super clean, zex nitrous kit, trans, clutch. flywheel, hasport mounts, wiring harness, everything you would need to get this running.

Here is some pics of the car and engine.

 

bump for a good guy

 

bro bump for a mean ass setup a....now lets see that in a ef .......lol


j/k bro make sure you stay firm dont let anyone low ball you that shit is nice

 

thanks for the bumps

 

no dont get rid of it! u have to finish!

 

i didnt know you could use a ls crank in a b16 block??? do you have custom lenght rods?

 

yes custom leanth rods. also the block had to be notched to clear the rods.

 

to the top

 

bump for nasty setup and a good seller !

good luck brian

 

This motor is redicously well built. TO THE TOP!