Drive Shaft not going in!!!!!!
Thread Starter
Registered User
Joined: Apr 2008
Posts: 4
Likes: 0
Drive Shaft not going in!!!!!!
Two questions:
1) I just had my tranny rebuild, and I installed it with a new clutch, new throwout bearing, pilot bearing, a slave cylinder. But now the drive shaft wont go in. The tranny shop said it could be the yoke or the bushing. Any suggestions?
2)Does anyone have a step by step on how to bleed the Hydraulics for the clutch. Everything is already connected, I have the fluid, but I got stunp when I tryed to use the a mitty vac to bleed it.
Thanks
1) I just had my tranny rebuild, and I installed it with a new clutch, new throwout bearing, pilot bearing, a slave cylinder. But now the drive shaft wont go in. The tranny shop said it could be the yoke or the bushing. Any suggestions?
2)Does anyone have a step by step on how to bleed the Hydraulics for the clutch. Everything is already connected, I have the fluid, but I got stunp when I tryed to use the a mitty vac to bleed it.
Thanks
__________________
How can you tell if your wife is dead?
The sex is the same but the dishes pile up.
How can you tell if your wife is dead?The sex is the same but the dishes pile up.
