I needed a section of 2.5" aluminum pipe welded to my stock throttle body elbow to complete my intercooler piping, lacking the equipment and skill to weld aluminum. I took the elbow over to CFP and Sean had the stock elbow cut off and a 2" section of 2.5od aluminum pipe welded on, and beaded the end for me. It only took him about 30 minutes after I popped in without much notice, and he only charged me 20 bucks including the pipe, which is better than I could find at several places. I give them "props" .

 

Yep they welded up my fogger bung for me they do good work from what ive seen so far.

 

they did my wire harness. there good people.

 

Where are they located?

 

Not all.

I love CFP. It's where i hangout once every while, and meet new friends. They also do car works.
They do have their down side, but the goods over weighs the bad really nicely.

 

http://www.centralflperform.com/ Right off of I-275 on 118th Ave. near the pinellas co. solid waste plant.
Get off the 3rd exit after the franklin bridge, then make a left on 118th, and they will be on the right one football's length.

 

Thank you for the information. I might need to take some things to them for some custom work.