FS: A LOT OF PARTS!!! B-Series, strut bars, + a TONS MORE
First of I am located in Venice, which is about an hour south of tampa off I75. You can reach me through pm or can call me at 941-468-3467, the name is Anthony.

B&M FPR ALREADY INSTALLED - $25

Stock gsr IM - $10

MSD Ignition Wires $10

8" slim fan $15


dual core full sized radiator $50

2 sets of stock gsr headstuds $10 each

stock gsr air intake shit


stock gsr exhaust $50

TCS rear strut bar SOLD/ No name front strut bar painted black for $15. both of a GSR

short ram intake pipe with a threaded port for nitrous?? $10

battery box $5


spoot cat. not sure what its for, but i think its for an accord. $25

RESISTOR BOX - $10 EACH

OBD1 INJECTOR CLIPS - $7

SET OF KONIGS - $125 (one of them has a small crack on the INNER lip of the wheel. Tire will still hold air and the rims does not wobble. I will take pics of the crack ASAP!) Also they are 15" and will fit any 4 lug honda.



GSR OIL PAN TAPPED BUT DENTED WHERE IT CONNECTS TO THE BLOCK - $35


OEM GSR RADIATOR UNKNOWN CONDITION LOOKS GOOD THOUGH - $30



T3/T4 REV HARD REPLICA MANIFOLD FOR B-SERIES - $30

OIL PUMPS - $10 each (not sure of condition of all)
WATER PUMPS - $10 each
PISTONS/RODS FOR GSR - $10
OIL PICK UP FOR GSR - $5
OBD2 CRANK POSITION SENSORS - $5
REAR MAIN SEAL - $10
OBD2 TIMING BELT GEAR - $10

B&M FPR ALREADY INSTALLED - $25

Stock gsr IM - $10

MSD Ignition Wires $10

8" slim fan $15


dual core full sized radiator $50

2 sets of stock gsr headstuds $10 each

stock gsr air intake shit


stock gsr exhaust $50

TCS rear strut bar SOLD/ No name front strut bar painted black for $15. both of a GSR

short ram intake pipe with a threaded port for nitrous?? $10

battery box $5


spoot cat. not sure what its for, but i think its for an accord. $25

RESISTOR BOX - $10 EACH

OBD1 INJECTOR CLIPS - $7

SET OF KONIGS - $125 (one of them has a small crack on the INNER lip of the wheel. Tire will still hold air and the rims does not wobble. I will take pics of the crack ASAP!) Also they are 15" and will fit any 4 lug honda.



GSR OIL PAN TAPPED BUT DENTED WHERE IT CONNECTS TO THE BLOCK - $35


OEM GSR RADIATOR UNKNOWN CONDITION LOOKS GOOD THOUGH - $30



T3/T4 REV HARD REPLICA MANIFOLD FOR B-SERIES - $30

OIL PUMPS - $10 each (not sure of condition of all)
WATER PUMPS - $10 each
PISTONS/RODS FOR GSR - $10
OIL PICK UP FOR GSR - $5
OBD2 CRANK POSITION SENSORS - $5
REAR MAIN SEAL - $10
OBD2 TIMING BELT GEAR - $10
__________________


#32!!
**If you are apart of the DC Crew and would like a DC crew Sticker shared_pm me!!**


#32!!
**If you are apart of the DC Crew and would like a DC crew Sticker shared_pm me!!**
Last edited by 95dc2teg; Feb 22, 2009 at 09:15 AM.
pm me location also i would like the msd wires/fan and give you 20 for just the muffler if you will sell it
__________________
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
pm's replied to!
15 for all
I am located in venice which is about an hour south of tampa off I75
Will do.
I will post better pics and prices in the OP asap.
15 for all
I am located in venice which is about an hour south of tampa off I75
Will do.
I will post better pics and prices in the OP asap.
__________________


#32!!
**If you are apart of the DC Crew and would like a DC crew Sticker shared_pm me!!**


#32!!
**If you are apart of the DC Crew and would like a DC crew Sticker shared_pm me!!**



