WTB ASAP! Crank Pulley bolt
--------------------------------------------------------------------------

Yea mine fell off during some heavy driving and cornering. I found the N1 pulley but now need the bolt and "key" I'm hoping someone local has one or someone can send it like next day air....

 

Well I got both but I'm all the way in tampa

 

I checked online- the dealer doesn't sell them for much, should be less than 15 for both new. I don't think it will be cost effective to drive down to you and pick them up, unless the price was really low (or free). Thanks for the response bro.

Mike

 

yeah bro you can find those keyways from the dealer for like $4, thats the way i would go......

 

Ideally I would have loved to get that stuff today, but the dealer parts dept is closed (WTF!) I was lucky to find the N1 crank pully on the sidewalk near the turn I took

that was the most expensive part, it didn't look to bad either. luck I guess, I have to make sure to put plenty of lock-tight on the new bolt so it doesn't happen again

 

here is my project car (currently DD too)
Slideshow of Medium Show - Photobucket - Video and Image Hosting

 

Double check to make sure the bolt is going in all the way. I have seen on other pulleys the shoulder of the bolt is to big to go pass the initial opening on the pulley.

Hope that made sense!

 

ummm yea I think, LOL.... I will try and see if the bolt used for the N1 pulley is the same as the B16a bolt. If not can I use it???? back to researching...

 

hey big mike!
i got one too but like ya said it's a long way to drive all the way from O town for it. lol
you can pick it up tomorrow at the dealer or even NAPA .
good luck brotha !!!!

 

Yea man.... NAPA I wonder if there open today?!


BRB...