Up for grabs is a Pre-Programed Single eprom chip for you to use with a supported obd1 ecu which is already socketed & ready to accept a 28 pin eprom chip. It is a Skunk2 Program that was loaded by (John) Phearable for my (R.I.P) '00 Honda Civic Si b16a2.
I never got the Chance to run the program, But It's Setup for Stage 2 Skunk2 Cam Setup.

I think John Charges $30 for something like this, But I'm not interested in making Big Bucks Here......I have no use for it anymore so......Make A Realistic Offer and It's Yours

I'd rather see Someone else get use out of it...... then me look at it (And wish I still had Vtack) everytime I open my Top Drawer and search for a matching pair of socks..

If I Remember correctly, The Chip has the : A/C full throttle cut-off, 2 step (launch control) with a CEL shiftlight, And Disabled Speed governor, Knock sensor, & Vtec speed limit....Plus a Dyno Proven Program for max power while running Skunk2 2nd stage Cams.

Make Offer!!!!!!

-Jeff

 

whats the vtec setup at and the revlimit at..?

 

If I Remember Correctly.
Vtec engauges at 5400
Revlimit sits at ......I Wanna Say 8500rpm but I'm not 100% sure.

Let me check with John and see if he still has the specs saved in his PC under my name.

 

yes list all specs of ecu.. thanks..

 

I PMed John Vega for the info, But no reply yet..........

 

pm me a price for it, i was going to have him burn me a base map for my new cams but i might just pick this up

 

LMK what you wanna Spend and it's yours Bro.
John Usually Charges $30+, But I'm not looking to sell it for that.

First Come First Serve, It's not doing me any good just sitting here in it's little Case.


-Jeff

 

im going to pm john and see if it will work well with my set up. i will let you know.

 

OK, Keep me posted

 

***SOLD!***