I need help from anyone that has swapped an LS motor into an EK hatch they are both obd2 i have done motor rebuilds but i have never swapped a D-series motor with a B-series motor. If anyone can come up with a list of parts needed and from what car they come from please do so. This is my daily driver and I need to make sure that I have everything I need before I start.

As of right now I have:

Motor, Tranny, shift linkage, mounts, cv axels w/ intermediate shaft, clutch, flywheel, header, ECU, catback exhaust, highflow cat, and have changed all gaskets I also have the rear motor mount bracket from a B16A3


If there is anything else i am missing help me out


Thx in advance for all your help

 

ttt

 

you have to change the plug for the map senosr and the tps if i remember correctly. go on to ff squad...do a yahoo search they will tell you there...

 

Do you have the same swap? If so did you use your civic wiring harness??

 

ttt

 

ttt

 

ttt

 

oh yeah i did use the stock wiring... go on ff squad...

 

wow im doing the same but in a coupe...i am wondering if you gt all of that fro honda and where did you buy it from...is it all for your ls motor? ive never done a swap like this just h series motors so this is new to me

 

for the wiring harness...you will need to change your 3 wire iac to a 2 wire by leaving the orange one taped off. you will not be needing it. and repin the wiring harness. and you need to change your 3 wire crank position to a 2 wire.