H22 Civic EG Hatch: Project LOW LOW Boost

[NeKe1point0]

This is one of our on going project cars. If you have been to our shop or stay up to date on our shop forum, you know we do things a little differently around here.

Unlike most shops that purchase manifolds and simply bolt them on. We make ours from scratch.

here is our maniold



Here is a basic breakdown of things to do:

Wire tuck
Weld/shave engine bay
Box frame
repaint bay
custom Proven Power turbo manifold
custom Proven Power exhaust
custom Proven Power charge pipe
and more to come...

So we started with cutting/grinding front core support to make room for the new Precision turbo. Then we centered the intercooler nad mounted it up...





Next we uninstalled the sweet NA header that came on the car...





Once we got a better look at what we had to work with we raised the turbo up into position.





After measuring & measuring and taking even more measurements we went ahead and tacked the collector for mock up.



Then we went ahead and got our num 1 runner all welded in so that we could remove the steel rod we welded to the frame.



Then we went on to the next runner







and now to runner num 3







Once number 3 was all welded we remounted the turbo and rechecked fitment to make sure everything was EXACTLY where we planned it to be !



Then we started cutting the bumper for a flush fitment



Everyone likes weld pics





We couldnt handle it so we took the tape off for a sneek peek



Come back for more tomorrow !

[BlackZ28]

nice! i need to stop by and check it out!

[NeKe1point0]

Stop by sun ! Dyno day !

[NeKe1point0]

Thanks, were tryin to keep up with you big dogs

[TheRedDragon]

keeping up u r

[NeKe1point0]

Total sleeper

Ok maybe not...

[Skee]

that's bad ass dude but what about rocks ?

[NeKe1point0]

This is car is not daily driven.

We made sure to leave enough clearance for a filter to be installed if driven on the street.

[BlackZ28]

Stop by sun ! Dyno day !

damn thats right, i didnt even realize it was so soon. ill more than likely be there and ill also put my h22 on the rollers to see where its at

[NeKe1point0]

Nice ! H22 Powa !

[marktopia]

damn. nice work guys. ill be there sunday. was going to stop by today and say hey but figured ill just wait till sunday lol.

[BABILLARACING]

nice looking welds .keep it up...

[tranceologist]

Holy turbo batman! Not worried about road debris or a BIRD ??? Bad enough the poor bird gets hit buts gets ground up too lol

[NeKe1point0]

Holy turbo batman! Not worried about road debris or a BIRD ??? Bad enough the poor bird gets hit buts gets ground up too lol

This is car is not daily driven.

We made sure to leave enough clearance for a filter to be installed if driven on the street.

[TheRedDragon]

Read people read