Datsun Dreaming

[KRUKED]

That's the best film that I have seen this far. Totally bad ass! On a side note, I started body work on the coupe today

[170k240]

pretty funny video.

[LongFellow]

Test fit...

S14? How much did you get that for?

[mewantkouki]

Yep, it's a 2.3L s14 engine from a 91 e30 m3. Basically picked up a front clip for $4500 shipped. Pricey compared to Nissan stuff, but a steal in the BMW world. Car it's going in is a 76 2002.

[KRUKED]

Got everything sanded except for the only bumper that I have, the panel between the tail lights, the fenders and the grey portion of the car. I'm thinking about pulling the fenders more because once I get some rucas, the tires will throw out about another 1/2". Meaning I'll have nearly an inch hanging out past what's pulled at the moment. Still trying to decide if I'm going to put the bricks on or sell what I got and go w/ a kouki.

[LongFellow]

Yep, it's a 2.3L s14 engine from a 91 e30 m3. Basically picked up a front clip for $4500 shipped. Pricey compared to Nissan stuff, but a steal in the BMW world. Car it's going in is a 76 2002.

Dream car.

[mewantkouki]

Should be a fun little car when it's finished. Full restos aren't cheap though.

[Under Pressure]

Yep, it's a 2.3L s14 engine from a 91 e30 m3. Basically picked up a front clip for $4500 shipped. Pricey compared to Nissan stuff, but a steal in the BMW world. Car it's going in is a 76 2002.

My friend has a '91 M3 E30, and OMG, the car is fuckin amazing! Are you going to box flare the 2002?

[David48]

I finally got a job so I can stop being a broke dick bum

[markstheman365]

2.3L s14 engine

glad i read whole post........mind was almost fucked.

[burgy240]

picked up some Evo Front calipers. going to clean then up and they will go on the Q! Anyone have Evo8/9 Rotors for sale??

[c89s13]

Nice. I been keeping an eye out for a set. A couple weeks ago i missed out on a full set for super cheap. How much work does it take to fit them into a q? Is it the same as a s-chassis that just requires the bracket?

[burgy240]

^ Yup...same. I need to have the brackets made or if I get in a hurry I may just buy them.

[obituary]

speaking of rotors ,i made some wheel spacers out of some old 4 lug ones , put in metal lathe and cut the rotor part off .

[-Mike]

That is a lot of extra weight to be adding.