You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features.
By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the TampaRacing community today!
pop your hood there should be a lil valve like this going intot he firewall make sure its open
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
theres a cable that goes from the hot or cold lever to the the vent control box and then to that valve. check the cable. the cable moves the doors aroung in the box so the air passes over the heater core, if the doors are broken or the cable isnt moving them you dont get heat...also you might have the heater hoses hooked up wrong. also the heator core could be clogged.
That valve is called the heater control valve. Turn the car on and let it warm up. Feel the hoses on both sides. Then switch it on the inside, the other way, then feel again. One is going to be hot (assuming your coolant is full), the other side should get hot if its open. GL!