PDA

View Full Version : 383 LT1 built motor 4,000

Na306StAnG
08-18-2008, 03:02 PM
Customer has changed his mind and is going with an LSx swap. Sorry for the cell phone pic but it was all i had. There is an EASY 9,500 in this motor, Its never been fired and is awaiting the right person to pick her up. Every nut bolt and part on and in this motor is BRAND NEW!!!! Delivery and installation is available.

LT1 350 30 Over.

Lunati 4340 Steel Crank.

Oliver Steel rods

Je/Srp Reverse Dome Pistons/ Plazma Moly File fit rings

.509 .528 Hyd roller N/A Crane Cam

AFR 210 fully Ported heads 65cc
with Comp cams pro magnum rockers

ARP studs through out the motor.


http://i16.photobucket.com/albums/b37/na306stang/for%20sale/DSCF0048.jpg
http://i16.photobucket.com/albums/b37/na306stang/for%20sale/DSCF0047.jpg
http://i16.photobucket.com/albums/b37/na306stang/for%20sale/DSCF0049.jpg


Shaun@
All American Street Car Performance
6428 123rd Ave North
Largo Fl 33771
(727) 667-9346
All-American Street Car Performance (http://www.aastreetcars.com)
SilverSleeper
08-18-2008, 05:17 PM
looks good and very similar to what i want to build. unfortunately i am not in the position to take it off your hands so "bump" instead. btw what ratio rockers and what cam was used?
Na306StAnG
08-18-2008, 09:09 PM
looks good and very similar to what i want to build. unfortunately i am not in the position to take it off your hands so "bump" instead. btw what ratio rockers and what cam was used?

Thanks for the bump, Ratio is 1.5 and I'm awaiting the cam card from the customer.
Stealth Mode
08-19-2008, 05:57 AM
sweet price, it would good in my trans am, lol.
wmskateteam
08-19-2008, 12:56 PM
what's the comp ratio? any intake/injectors/TB?
Na306StAnG
08-19-2008, 01:14 PM
what's the comp ratio? any intake/injectors/TB?

9.5-1 And it was going to be carbureted.
Na306StAnG
08-19-2008, 04:37 PM
updated with new pics
Na306StAnG
08-22-2008, 10:10 AM
ttt
Corner Worker
08-22-2008, 07:12 PM
nice, I would be in the market as well, but a little more compression than what I am looking for. GL with the sale.
Na306StAnG
08-22-2008, 07:55 PM
nice, I would be in the market as well, but a little more compression than what I am looking for. GL with the sale.

That 10.5-1 was a misprint, Sorry!! A dish piston and a 65cc chamber will never make 10.5-1 :lol: It is 9.5-1
Corner Worker
08-23-2008, 01:52 PM
PMed