ownedbypandas
05-22-2008, 03:31 PM
Anyone want to take over my GTS corolla project?
-Clean title
-no motor
-no tranny
-Comes with LSD
-Brembo blank rotors(front, about 300 miles on them)
-Hawk pads(front, about 300 miles on them)
-Tokico blues
-Espelier springs(not sure on kg)
-JIC inner tie rods
-T3 camber plates
-Rear sway bar bushing
-Holley fuel mechanical fuel pump
-Toms steering wheel
-Fuel delievery is set up for Carbs.
-Has dents on the driver side door(can be pulled with a plunger). Passenger side fender is black. dent on driver side fender. no interior(sound detinating material has been removed, i do have carpet though). No seats.
-Asking 1500 for the chassis
I also have a bus load of high compression carb goodies that can go along with the car. :)
-Clean title
-no motor
-no tranny
-Comes with LSD
-Brembo blank rotors(front, about 300 miles on them)
-Hawk pads(front, about 300 miles on them)
-Tokico blues
-Espelier springs(not sure on kg)
-JIC inner tie rods
-T3 camber plates
-Rear sway bar bushing
-Holley fuel mechanical fuel pump
-Toms steering wheel
-Fuel delievery is set up for Carbs.
-Has dents on the driver side door(can be pulled with a plunger). Passenger side fender is black. dent on driver side fender. no interior(sound detinating material has been removed, i do have carpet though). No seats.
-Asking 1500 for the chassis
I also have a bus load of high compression carb goodies that can go along with the car. :)