Just to start off i need to get this fixed A.S.A.P.

I just put a new input shaft bearing in my 90 dx tranny and while i was reassembling it i noticed that it would not shift. I have another tranny to reference from but can't use because it is a hydro and i have cable.

Now i seriously need a very detailed write-up on how to get it right or have somebody come over and "show" me what i am doing wrong. Now with that said the reason i said "show" me is because i am very short on money just like the rest of us, so to pay someone to do this is out of the question but if you do come help me i can take you to Wendy's for a double stack and some fries. If you would like to call me and tell me when you can come over or just walk me through it you can call 813-863-0853.

 

please throw some ideas at me

 

Make sure all your forks are on straight and keep in mind it wont be the easiest thing to shift being that you have little to no lubrication.
Make sure you have some leverage, just not enough to go force things and break something.

Ive found it easier to shift while spinning the input shaft.