obd1 swap questions

Reply Subscribe

Thread Tools

Sep 11, 2002 | 12:24 PM

#1 (permalink)

specie

Thread Starter

Registered User

Joined: Oct 2000

Posts: 498

Likes: 0

obd1 swap questions

This is going in a '95 Integra GSR. I'm new to the obd1/hydro. I'm planning on either putting my ls/vtec or just get a ls swap and turbo or spray it. What axles would I need? Are all '94 up B-series axles the same? If I was to do the ls swap, is there any wiring changes? I had to add/move 4 wires when I did the vtec conversion in my Crx. However, I did run it for two weeks with the ls ecu and had no problems? I'm assuming I can keep the wiring the way it is?

Are all B-series shift linkage the same?
Is a obd1 distributor different from a obd2?

Thanks.

Sep 11, 2002 | 12:49 PM

#2 (permalink)

Cronic

Guest

Posts: n/a

I think all B series axles are the same. Wiring will be different. go with LS+boost swap. more reliable. You will have to change the wire harness unless you can get the ECU from an LS obd1