got a 2g eclipse awd converted, the motor is stripped down to the block. Do i need to take the motor and tranny out at the same time or can i just yank the engine. The motor is mated to a 5 speed

 

if everything is disconnected pull the axels out of the tranny and just pull it out as one.

 

i always left the transmission in. take the transfer case off and yank the block by itsself. taking apart the suspension to get the axles out is a pain in the 2g's haha. just put a jack under the tranny to tilt it up, and when you go to put it back in, just tilt the tranny back up to slide the engine in.

 

^^^you would know best, considering on what im working on

 

yank the tranny and mottor out all in one i did my car in about an hr and i had to disconnect everything(wires,exhaust,axels, etc)... this was all done in my driveway with a engine hoist and a friend... also drop everything back intogether the only trouble i had was i had to take the crank pully off because it wouldnt clear the driver side motor mount... no biggie just do it first... i have 98 eclipse 2g...