Skipped the 13s !!! Watchout 4sefed4 !!

[Bob87GN]

Hey everyone Great news!! I went to Test and Tune @ Desoto today. My previous best time was 14.04 @98 MPH. That was with all the original parts with 145000 miles on them. After the install of a K&N Walbro 307 fuel pump new timing chain Valve springs slicks open exhaust and my new SMC Alky Kit I went 12.85 @103 with a 1.79 60-foot time!! Im thrilled!!! This was at 19 PSI 26 Degrees advance and using 93 octane gas. I used straight Denatured Alcohol which worked perfect!! Later I raised the timing to 29 degrees and 22 psi and still had no knock. Lack of traction made the times the same but it felt a lot stronger. The car has the stock rear rubber bushings so when I launched harder than 5 psi the car went kinda sideways... Definitley a fun ride!! 11s Here I come!!!

------------------
BM Computer Source
http://www.bmcomputersource.com
Automotive Software for GM and others soon!
1987 Buick Grand National working to be an 11 second 1/4 mile AutoCrossing GN!
Moderator Scantool section of www.turbotransam.com (http://www.turbotransam.com) http://www.bmcomputersource.com/b18.jpg

[4sfed 4]

Thats Mr. 4SFED http://www.tamparacing.com/ubb/biggrin.gif hehehehehhe

4SFED 4 will be ready very soon. But you had better get your trap speed up at least 10-15 mph if you wanna play. hehehehehehe. 4SFED 4 is a street killa!

Congrats on skipping the 13s. I agree they are a complete waste of time. Why mess with em?



------------------
Larry
2000 Nissan Maxima SE 5 speed Mad Max
14.38 @ 96.62 (2.13) - 203 hp/191 ft lb on Spec Rs Dynojet

1985 Dodge Omni GLH Turbo - 4SFED
Engine rebuild in progress....T minus 10 days until liftoff....A few weeks after that and 4SFED goes east to hunt whales!

[TealTalon]

Hey Bob was this you in this video?

Nice job of running away from me at the 1/8 mile if it was. http://www.tamparacing.com/ubb/biggrin.gif
http://web.tampabay.rr.com/7seconds/13.5@96.MPG

[4sfed 4]

Originally posted by "Someone"

Originally posted by TealTalon:
Hey Bob was this you in this video?

Nice job of running away from me at the 1/8 mile if it was. http://www.tamparacing.com/ubb/biggrin.gif
http://web.tampabay.rr.com/7seconds/13.5@96.MPG

Who didnt run away from the TealTurd in the second 1/8th? Im pretty sure I saw a 1983 Ford Escort escorting you down the second 1/8......


------------------
Larry
2000 Nissan Maxima SE 5 speed Mad Max
14.38 @ 96.62 (2.13) - 203 hp/191 ft lb on Spec Rs Dynojet

1985 Dodge Omni GLH Turbo - 4SFED
Engine rebuild in progress....T minus 10 days until liftoff....A few weeks after that and 4SFED goes east to hunt whales!

[glhsken]

Great time Bob!!! congrats. If youre gonna run 4SFED you better keep that 60 time down there hehehe or he will hunt you down in the last 1/8. The turbo dodges arent the greatest in the 1st 1/8 but watch out for the second!!! (traction on FWD is tough)... What was your 1/8 time and MPH if the slip shows??? Just curious.

Also Your time is dead on with a GNX I ran... 12.85 @ 104

[TealTalon]

Originally posted by "Someone"

Originally posted by 4sfed 4:
Who didnt run away from the TealTurd in the second 1/8th? Im pretty sure I saw a 1983 Ford Escort escorting you down the second 1/8......




Hahahaha not quite that bad but I need to take my ass back to sunshine for When V8s attack part 2. No room for them to walk me there. http://www.tamparacing.com/ubb/smile.gif

[Bob87GN]

Thanks everyone! My 1/8 mile info is:

8.150 @83.99 MPH. Dont worry I havnt bolted on any performance parts yet!! Ive set a goal of $1500 total layout of money for me to get to the 11s. So far I have spent $300 of it on the Alky Kit. that was not necessary but it allows me to run high boost without race gas. The parts Ive put on the car have all been replacement of worn pieces like the timing chain valve springs and fuel pump.

------------------
BM Computer Source
http://www.bmcomputersource.com
Automotive Software for GM and others soon!
1987 Buick Grand National working to be an 11 second 1/4 mile AutoCrossing GN!
Moderator Scantool section of www.turbotransam.com (http://www.turbotransam.com) http://www.bmcomputersource.com/b18.jpg

[Bob87GN]

By the way that was not me in the video but a friend who was running lke 109-110 mph... He left you in the 1/8 because he was getting 2.1 60 foot times... I want 115 mph and an 11.60 et. Ill get there sooner or later!!

------------------
BM Computer Source
http://www.bmcomputersource.com
Automotive Software for GM and others soon!
1987 Buick Grand National working to be an 11 second 1/4 mile AutoCrossing GN!
Moderator Scantool section of www.turbotransam.com (http://www.turbotransam.com) http://www.bmcomputersource.com/b18.jpg

[camryDAN]

haha great bob. i didnt get a chance to talk to u yesterday but as u can see i was sitting on the bleachers at the bottom of the end of that video! woohoo im on tv...err...internet video! woohoo http://www.tamparacing.com/ubb/biggrin.gif

[LeadSled1]

Congrats Bob. It was good to see the Buick guys out at the track. I had a blast and some good runs down the 1/4 also. I had the red LS1 Z28. Ill see you guys out there again soon.


jess

------------------
99 Z28 A4 3.23
Lid/FilterMAFMACs/ORcutout!tbMw3200
321rwhp/330rwtq The Sled (http://www.zyworld.com/10795247.fc/The%20Sled.htm)
stock vs mods dyno (http://www.geocities.com/leadsled11999/Mvc-006s.jpg)
Time slip (http://www.geocities.com/leadsled11999/Mvc-008s.jpg)

[emodsm]

God job bob!!!....who needs those stinking 13s anyway!

eric

[4sfed 4]

Originally posted by "Someone"

Originally posted by emodsm:
God job bob!!!....who needs those stinking 13s anyway!

eric

Ill bet you wouldnt mind you jackass!


------------------
Larry
2000 Nissan Maxima SE 5 speed Mad Max
14.38 @ 96.62 (2.13) - 203 hp/191 ft lb on Spec Rs Dynojet

1985 Dodge Omni GLH Turbo - 4SFED
Engine rebuild in progress....T minus 10 days until liftoff....A few weeks after that and 4SFED goes east to hunt whales!

[Bob87GN]

LeadSled-- That Was you wasnt it!!! I ran a red Z28 at had an even run down to the last 1/8th then it pulled away from me. I ran a 12.89 @104 on that run I think it had to have run a low 12. I looked at your webpage and your slips show a 12.2 or so... Was that you!!?!?!?

-Bob


------------------
BM Computer Source
http://www.bmcomputersource.com
Automotive Software for GM and others soon!
1987 Buick Grand National working to be an 11 second 1/4 mile AutoCrossing GN!
Moderator Scantool section of www.turbotransam.com (http://www.turbotransam.com) http://www.bmcomputersource.com/b18.jpg

[LeadSled1]

Hi Bob that was me.http://www.tamparacing.com/ubb/smile.gif I ended up running you on the 12.222 run I think. I wish I knew you where there I would have stopped by to talk to you. Where you still there when we were pushing Tommys M3 out of the gates?


jess

[Bob87GN]

Yeah I was there changing the slicks out for the street tires so I could drive home when the BMW came rolling by. That BMW really moves! Good race by the way!! Hopefully Soon Ill be in the low 12s too or high 11s. Are you running NOS?

-Bob


------------------
BM Computer Source
http://www.bmcomputersource.com
Automotive Software for GM and others soon!
1987 Buick Grand National working to be an 11 second 1/4 mile AutoCrossing GN!
Moderator Scantool section of www.turbotransam.com (http://www.turbotransam.com) http://www.bmcomputersource.com/b18.jpg

[LeadSled1]

Bob no NOS. My car currently holds the record for boltons only on street tires. Joe is right behind me by about 4/100ths so it is close.


jess

[glhsken]

Bob

you listed a 8.15 1/8... what the heck was that 60... must have been killer. we are both at bests of 12.85 now... my third digit was a 7... what was yours??? http://www.tamparacing.com/ubb/wink.gif my pass that netted the 12.85 was a 8.34 1/8. and good luck when 4sfed gets running...

[glhsken]

never mind I saw the 60 1.79.... I would kill for one... great driving

[87GTA355]

goodtimes bro..especially with high miles its amazing what a littles boost will do for ya http://www.tamparacing.com/ubb/smile.gif

------------------
87GTA superrammed 355
Lets play a game! how about...Lion you roar and ill slip ya the meat!
best time with a G-TECH was 12.9 @ 110mph spun first & stock TB...not bad i guess????

[Bob87GN]

Thanks!! Im addicted to boost! My run was at 19 psi on 93 octane gas. Next time I go back im using 112 leaded and 22-23 psi. Im looking for low 12s. OOOOOOOHHHH BABY!

------------------
BM Computer Source
http://www.bmcomputersource.com
Automotive Software for GM and others soon!
1987 Buick Grand National working to be an 11 second 1/4 mile AutoCrossing GN!
Moderator Scantool section of www.turbotransam.com (http://www.turbotransam.com) http://www.bmcomputersource.com/b18.jpg

[Bob87GN]

congrats bob glad to hear about the great times being ran at the local track keep up the good work!

------------------
teal 94 integra gsr 99 saw blades aem intake &cam gears. moderating since sep. 2000
skunk 2 coilovers