valve cover painting

[oASHo]

was is the best in house way to paint a valve cover and not half ass it have it actually look decent?

[84 Fila]

Mine is totally different then yours I'm sure, but I sanded mine first with 600 grit.
http://i140.photobucket.com/albums/r9/84fila/DSC00117.jpg

Then shot a few coats of flat black
http://i140.photobucket.com/albums/r9/84fila/DSC00118.jpg
http://i140.photobucket.com/albums/r9/84fila/DSC00119.jpg
http://i140.photobucket.com/albums/r9/84fila/DSC00120.jpg

sanded the fins and words to keep them allumnium
http://i140.photobucket.com/albums/r9/84fila/DSC00122.jpg
http://i140.photobucket.com/albums/r9/84fila/DSC00123.jpg
http://i140.photobucket.com/albums/r9/84fila/DSC00125.jpg

then 4 coats of clear for the finished product
http://i140.photobucket.com/albums/r9/84fila/DSC00126.jpg
http://i140.photobucket.com/albums/r9/84fila/DSC00127.jpg
http://i140.photobucket.com/albums/r9/84fila/DSC00128.jpg
http://i140.photobucket.com/albums/r9/84fila/DSC00140.jpg
http://i140.photobucket.com/albums/r9/84fila/DSC00135.jpg
http://i140.photobucket.com/albums/r9/84fila/DSC00136.jpg
Not to bad for a job that cost me under $50 and gets a fuckin awsome look on a set of 83-6 Stang 5.0 Covers!

[oASHo]

not bad. i was looking for a glossy finish to be honest

[84 Fila]

I guess do with a gloss paint and a gloss clear? I did flat black and just a matte clear coat

[elwrestler03]

its easy get gloss paint but make sure it can with stand high temps. prep ur valve cover u should take it off. If it has paint on it use aircraft paint remover found at wal-mart or discount. remove dirt paint and all the nasty stuff tack it with a tack cloth can be found at wal-mart and spray it in thin coats so it doesnt run or anything and spray it every 15-20 min till desired look.

[SneezinCD5]

Here is a shot of the VC's I did for my Accord. F22 and H23 along with the intake pipe.
I used PPG base/clear to match my car.

http://i133.photobucket.com/albums/q75/Sneezincd5/jason412.jpg

http://i133.photobucket.com/albums/q75/Sneezincd5/jason410.jpg

http://i133.photobucket.com/albums/q75/Sneezincd5/jason348.jpg

http://i133.photobucket.com/albums/q75/Sneezincd5/jason405.jpg

http://i133.photobucket.com/albums/q75/Sneezincd5/Jill463.jpg

http://i133.photobucket.com/albums/q75/Sneezincd5/Jill354.jpg

[GaitherSRT4]

^^^^nice work. Thinking about doing mine. Im not the greatest painter though. Always try to spray too much.

[SneezinCD5]

Wet dat hoe up ;)

[elwrestler03]

oh and you need to put down some primer before you paint it

[oASHo]

thanks guys