Couple questions on tubro postions on SRT-4?

[Sippi]

Ok I know that tha turbo is mounted in the rear of tha engine bay. And plz don't negative rep me but its been a while since I've seen under tha hood but I'm sure that means thats where tha exhaust/turbo manifold is?

My questions is I've seen it on a video where tha turbo was actually mounted up front like maybe a towards tha drivers side so it can be done but how hard is it?

I'm sure this would mean a lot of custom work and a good bit of money but I'm sure it would be worth it due to an easier postion to work on rite?

[FLNeonRT]

Yes and no. You still need room to plumb the exhaust all the way to the turbo and then awat from it and if your using a lrage turbo, that takes up room also. I'd be removing as much as I could from the engine bay and moving everything else lower. You also have to plumb intercooler lines, oil feed and drain lines.

[Figs]

Your better off leaving it around the stock location. Even though depending on what you want to do its a pain to get to. The turbo, manifold, o2 housing and downpipe are in the rear of the engine.

Whenever replacing any part back there usually like a O2 Housing you might as well do everything all at once... ported manifold, 3" O2 Housing, 3" Downpipe, ported and clipped turbo or one of those re-worked stock turbo's like PTP's SST.

There's many other options... you could just go outside of stock bolt on parts and go with a bigger turbo and what not.

[Sippi]

ok cool!

[ACR2NV]

or you could buy an AGP cast manifold and the turbo options suddenly get pretty long :)