i have an 3 bar map sensor, if i go all motor would i still need that map sensor? thxs

 

Ttt

 

no you need your stock map

 

well i dont have the stock map, because i have eldlebrock ITM and had to switch to a 3 bar

 

if you have the Edlebrock VictorX mani, i would swap that out anyway if your going all motor, unless you plan to rev till around ~9500. That mani is mainly for high range power (6000-10000 rpms) which i belive would be bad for a all motor setup, but then again, im not an all motor guy, so maybe an all motor guy could chime in here.. I would try more of a SK2 intake mani.

also for all motor you will need the stock map sensor, seeing as you will not see any boost...

 

Your intake manifold really should not have to do anything with what map sensor your running.

You can run a stock throttlebody with a stock map sensor on a victorx manifold such as the one you have.

If you have a aftermarket throttlebody that does not have provisions for a factory map sensor, you can simply run a vacuum line from the intake manifold to the map sensor and mount it on the firewall.

 

yes i have one on the firewall already, so i'd be fine with the stock TB?

 

^ your ghey!

 

Your Car Will Not Run With The 3 Bar. Already Have Tried It

 

I already answered your question.

It will if it is properly tuned for the setup/injectors. Runing a 3bar map sensor on an na car is a waste of a 3bar.