WHAT PLUG WIRES ARE YOU USING? I have been using FRPP's but when I started measuring the Resistance(OHMS) I started getting numbers that kinda worry me. they are around 2000 ohms for my coil wire, I mesured 2 different sets and got around the same numbers. then Measured the MSD's and got 45 Ohms which was better, BTW my stock 10year old wires measured 980 Ohms. so The FRPP ones are worse than stock? so what is everyone using? buying new ones next week and am stuck between a few:
MSD SuperConductor's
Taylor
Crane
Moroso


I have a Crane Hi-6 and LX-92 Coil.

 

i use taylor pro 10.5s, and have used moroso ultra 40's withs stereo noise tho

 

i've got a good set of MSDs you can have for $30 plus the drive or $35 shipped

 

how old are they?

 

i had the FRPP's on my 98 GT and they worked really good. but i would go with a set of MSD's if you could swing a new set or buy SVT1996Cobra's.

 

don't know how old, not too old though, they've been in my closet for the last year though. They came off a 91 5.0 so the coil wire is longer than you need it but that wouldn't hurt anything.

 

I am trying the MSD wires, I used to run Taylor. I have heard some good things about MSD wires lately. I have had problems with FRPP wires in the past

 

my taylor pro 10.5 from what i've measured were about 31ohms on the coil wire, to around 40 ohms on the longest wire to the #4 and #8 wires i like my taylors

 

I have Taylor Pro's also.