Need Help

[City Boy]

ok i just bought an alpine cda 9851 deck and a rock ford fosgate amp p4004 im hooking everything up myself i hooked up the deck no problem the amp is hooked up right but how should i hook up my two 10' speakers and what levels should i put them at i get confused with that 2 ohm 4 ohm bridged bullshit looking for some help before i got back to best buy and have them do it thanks

[TIM TIM TIM]

ok first off, DONT have best buy do it, what kind of subs are they? are the dual or single voice coil? is it a 1 or 2 channel amp? this site may help with a wiring diagram.. http://forums.caraudio.com/vb/showthread.php?t=31984

[City Boy]

there polk audio i dont know about the voice coils how would i find out, as far as 1 0r 2 channel amp it has a place for 4 speakers (front left front right) (rear left rear right). right now i have them hooked up to the rear not bridged i think im gonna bridge them to see what it sounds like

[TIM TIM TIM]

theres no point to bridge them, to see if the speakers are 1 or 2 voice coil, look on the back of the sub and see if it has 1 place where wires connect or 2 places, if there is just one, its very simple, just positive to positive and negative to negative.

[STSHatch]

id run the speakers in series and bridge them...just for sound quality issues.... either way, the amp is going to see the same load. if u get ballsy, run them in parallel and bridge them, ull see a power increase but could damage your amp