Welding?!

[China]

which welding is the easiest? is there such thing? if you had to choose a weld technique which would it be? tig?Mig? self feeding? and which is the best for longevity for the intercooler piping?



thanks

[CodenameAcura]

If you want a nice clean look and a strong hold you will find someone who does a nice tig...

[Sneakin Deacon]

also it depends on the material, i believe MIG is hotter and is not recommended for aluminum and such...you'd have to look into it as im not positive.

[China]

any1 know of a place where i can pick up a tig welder for cheap?!?!

chinamin911@yahoo.com <----if you do!
thanks

[John]

71G \^/3ld3|2 15 7h3 0|\|ly ch01c3 y0u 5h0uld c0|\|51d3|2. M1G 15 700 l1m173d, 71G c4|\| \^/3ld 4ll 0f \^/h47 m1g c4|\| 4|\|d m0|23.

[China]

sounds good. thanks for the advice.

[Just Dave]

You can do almost everything with a MIG that you can a TIG, the weld just won't look as good. TIG is the most expensive, and hardest to learn, but is the best looking, and least damaging to the metal of any type of welding. My friend just bought a new TIG setup for $1200 or so off of some web site. He can do aluminum and stainless.

[CodenameAcura]

Yeah TIG welders are not cheap and TIG is for stainless and aluminum...It will be a much nicer looking, stonger holding wled if done the proper way. MIG is just ugly and not as nice of a weld...Our company uses Pinellas Pasco Welding supply and they sell welders new and used... Try them 727-443-2116